Omega-engineering DP3300 Series Manual do Utilizador descarregar pdf (Página 21)

DP3300 Series User’s Manual

Page20

FUNCTION DISPLAY SHOWS TO CHANGE

Latching or non - 'LATCH' for latching mode. Push ^v key to obtain alternate mode.

latching relay setup. 'NON LCH' for non latching mode.

Limit outputs prog- LT1 N.O. or LT1 N.C Use ^V key to obtain

rammed as normally LT2 N.O. or LT2 N.C alternate mode.

open or closed LT3 N.O. or LT2 N.C

SETUP FOR RATE MONITOR:

If channel 2 is programmed to operate in RATE mode, then the following steps are performed during SETUP procedure:

FUNCTION DISPLAY SHOWS TO CHANGE

Time base for RATE 'rAtE tb' followed by previously Push ^v key to increment or decrement active

calculation (In seconds) programmed value e.g. '1.999' digit. Push <NXT> key to make next digit active

Decimal point dP 9999 Push ^v key to

placement dP 999.9 move decimal

dP 99.99 point to desired

dP 9.999 position.

Scaler 'SCALER' followed by preset scaler Push ^v key to increment or decrement

value e.g. 10.00024 with active digit active digit. Push <NXT> key to change

flashing. active digit.

Division Factor 'DIV FAC' followed by preset division Push ^v key to increment or decrement

by preset division factor. (e.g. 12` active digit. Push <NXT> key to

with active digitflashing). change active digit.

Limit 1 'CH1 LT1' followed by preset Limit 1 Push ^v key to increment or decrement

Limit 2 value e.g. 123.4 with active digit active digit. Push <NXT> key to

Limit 3 flashing. active digit.

For limits 2 &3 CH1 LT2, CH1 LT3 NOTE: Limit3 is audio visual alarm only

followed by limit value. --- it has no relay output.

Relay deadband 'dEAdbd' followed by deadband Push ^v key to increment or decrement

value e.g. 0002 active digit. Push <NXT> key to make

next digit active.

Limit outputs prog- LT1 N.O. or LT1 N.C Use ^V key to obtain

rammed as normally LT2 N.O. or LT2 N.C alternate mode.

open or closed LT3 N.O. or LT2 N.C

SETUP FOR RPM MONITOR:

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

Omega-engineering DP3300 Series Manual do Utilizador Página 21